5 Causes and Solutions for Generator Overheating

29 December 2023

penyebab genset overheat

It is usual to use generators in workplaces, companies, or private residences, particularly if Sobat Honda resides in an area that frequently experiences blackouts. Sobat Honda should be aware of a number of things when using their own vehicles, one of which is what causes the generator to overheat.

The overheating condition is a common problem that often occurs in every generator engine. However, Sobat Honda can avoid these problems by knowing how to operate the generator properly and correctly.

Therefore, in this article we will help Sobat Honda to find out what causes the generator to overheat and what solutions can be taken when the generator overheats, here is the explanation.

5 Causes for Generators Overheating

When Sobat Honda encounters a blackout for a little or extended period of time, a generator is a very helpful piece of equipment. When a power loss occurs, the generator itself serves as a tool for supplying backup electrical power.

If used for a long time, the generator will usually experience an overheating condition. However, there are also several conditions that can cause the generator machine experience an overheating

To help Sobat Honda gain help to avoid a number of causes of generator overheating, Sobat Honda needs to know about several conditions and causes in overheating generator machine conditions. Including the following.

1. Reduced Cooling Water / Radiator Water

The first cause of the generator overheating is because there is less cooling water in the generator than usual. If the cooling water indicator shows a low level, then Sobat Honda must immediately fill the radiator fluid again.

Therefore, it is important for Sobat Honda to check the generator machine frequently, because there might be an unknown leak in the fluid tube, and that’s why, decreasing the amount of cooling water.

2. Cover the damaged radiator on the generator.

Sobat Honda needs to pay attention to this one point, despite the generator radiator cover appearing to be unimportant. Because even a minor deformation or damage to the generator radiator cap could prevent water from flowing freely through the radiator.

The generator engine temperature will significantly increase without enough cooling, which is the cause. The generator engine may overheat as a result, impairing overall performance. As a result, it's crucial to routinely inspect the radiator cap to make sure that it's in good shape and that no damage is obstructing coolant flow.

3. A Broken V-belt

The radiator fan is rotated by the V-Belt, also known as the fan belt, which runs between the generator engine and the radiator fan. The purpose of this radiator fan is to maintain steady radiator air pressure. The fan won't be able to run automatically if the V-Belt breaks, which would result in a sharp rise in the generator's internal temperature.

Due to an abnormal increase in temperature in the generator, it will have a negative impact on generator performance and damage components sensitive to high temperatures.

4. Leaking Radiator

The radiator or cooling system on the generator has an important role in regulating the temperature of the generator. If there is damage or leakage to the radiator, the temperature in the generator will gradually increase or overheat.

If the leak is not treated immediately, there is the potential for overheating of the generator which will disrupt the overall performance of the generator and ultimately damage the engine. Therefore, it is important to periodically check the cooling system, identify and repair any leaks found.

5. Lack of lubricating fluid (Engine Oil)

Lack of engine lubricating fluid (engine oil) is the last reason for generator overheating. The engine lubricant itself works to lessen friction between the engine's metal parts. So that the generator engine does not wear out or get dry, Sobat Honda should update the engine lubricant on a regular basis.

To prevent this, it is necessary to check the engine oil. This includes routine monitoring and replacing lubricant on Honda Power Product generators according to Honda Power recommendations so that overheating of the generator due to lack of lubricating fluid can be prevented.

6 Solutions When the Generator Overheats

After knowing the cause of the generator overheating, Sobat Honda also needs to know what solutions can be done when the generator overheats, some of which are as follows.

1. Take of The Burden

The first solution that Sobat Honda can do when the generator is overheating is to remove the load or turn off the switch that connects the generator to the load. Load here means the current load on the generator, not a load in the form of an object.

The thing that Sobat Honda must pay attention to when carrying out this step is to do it at the first step before moving on to the next step, namely turning off the engine. If possible, Sobat Honda could also let the generator engine run into idle mode (no load).

Doing this is much better for Sobat Honda to do compared to turning off the engine, because the engine cooling system will bring the temperature down more quickly than if the engine is left turned off.

2. Turn The Machine Off

If Sobat Honda has done the previous method, but the generator engine is still overheating, then Sobat Honda can immediately turn off the engine. However, if the cooling system is still functioning, Sobat Honda can wait for the engine temperature to drop to around 70-80 degrees Celsius before turning off the engine..

When the engine is off, the engine temperature will also gradually drop, but keep in mind that the engine can still maintain a high temperature for a few time. Therefore, it is really important to allow sufficient time for the engine to be cool before inspecting or carrying out further improvements

3. Helps Generators Dispose of Heat

If the generator cooling system is still running, but Sobat Honda do really need the generator to keep running like usual, then Sobat Honda can also help dissipate the heat in the engine radiator machine by flowing the water continuously over the surface of the engine radiator.

In doing this, Sobat Honda must be able to pay attention to the movement of the water temperature, whether it becomes stable or remains uncontrolled. If the movement remains uncontrolled, then Sobat Honda need to reduce the load, release it, and then turn off the engine.

4. Changing Generator Engine Oil

The oil contained in the generator engine has a significant effect in maintaining the engine temperature when it is working. Therefore, Sobat Honda need to change the engine oil in the generator regularly.

In addition to changing the oil regularly, it is also important to check the oil level periodically and top up if necessary. Ensuring the correct oil level in the generator engine is an important step in maintaining performance and preventing overheating.

5. Carrying Out Maintenance On The Generator Cooling System

The cause of a generator overheating can occur due to several factors, one of which is a damaged radiator or cylinder head, or a leak in the generator engine cooling system, as mentioned in the explanation above.

To overcome this problem, Sobat Honda can repair the cooling system on the existing generator engine, whether it is fixing leak problems, carrying out maintenance on the generator cooling system, or other things related to the problems currently being faced with the generator engine.

6. Refilling Radiator Water

The more frequently the generator engine is used, the more it can cause other things, namely that the coolant contained in the engine radiator decreases. This can happen because evaporation occurs in the engine radiator.

The coolant contained in the engine radiator not only functions to protect the engine system from corrosion, but can also function in other ways, namely to keep the engine cool. By repeatedly filling the radiator with water, Sobat Honda can prevent the engine radiator from rusting.

That's the information regarding the causes of generator overheating that Sobat Honda can find out. Through the explanation above, of course Sobat Honda already know what causes the generator to overheat, and what solutions Sobat Honda can do when they experience an overheating generator engine.

Through the explanation above, Sobat Honda can also know that the presence of a generator machine is quite important, especially if Sobat Honda live in an area that often experiences blackouts condition.

If Sobat Honda are looking for a good quality generator engine, then Sobat Honda can choose already the Generator - EZ3000CX from Honda Power. With the GP200 engine model, this generator from Honda Power has a continuous operating time of up to 7.3 hours. So, Sobat Honda can also use this generator engine in such quite a long time when there is a power outage.

Immediately find the best generator engine according to Sobat Honda needs only at Honda Power Products now!

Honda Power Products Indonesia

Honda Power Products menyediakan mesin serbaguna, generator, pemotong rumput, pemotong sikat, pompa air, dan mesin tempel.